Adjustment Procedure - Onkyo SKS-HT540B Service Manual

ADJUSTMENT PROCEDURE

SKW-540 : POWERED SUBWOOFER / ADJUSTMENT OF IDLING CURRENT
[When]
1. Exchange transistors (Q505 - Q519).
2. Exchange MAIN PC board ass'y (NAAF-8829).
[Procedure]
<Note> No speaker load and No input signal.
1. Short test point P631 for amplifier is under active mode.
2. Adjust the trimming resistor R544 so that the reading of multimeter becomes 52 ohm to 53 ohm.
3. Connect the DC voltmeter to test point P531. <Fig-1>
4. Connect the AC power cord into a wall outlet.
5. Confirm the voltage of above point after 6 minutes to 8 minutes. (Heat running)
6. When less than 3.20 mV : Readjust the trimming resistor above so that the voltage becomes 4.5 mV to 5.0 mV.
When 3.30 mV to 5.20 mV : Not necessary to adjust.
When 5.21 mV to 10.0 mV : Readjust the trimming resistor above so that the voltage becomes 5.0 mV to 5.5 mV.
When 10.1 mV to 20.0 mV : Readjust the trimming resistor above so that the voltage becomes 5.6 mV to 6.0 mV.
7. Disconnect the DC voltmeter.
8. Disconnect the AC power cord from a wall outlet.
Trimming resistor
R544
Test point
Test point
P531
P531
100 ohm
(1/4W) DC voltmeter
<Fig-1>
MAIN PC board ass'y "NAAF-8829"
SKS-HT540
Test point
P631
Short