Table of Contents
Advertisement
Charger
The green signal diode indicates
that B-phone is not charged.
A red signal diode indicates that
B-phone is fully charged, if it's
flashing then B-phone is still be-
ing charged.
CD with the B-phone software
GETTING STARTED
1. Charging
Connect the charger to the „Charging slot" (7).
B-phone has an incorporated lithium battery and it can be char-
ged whenever you consider it necessary. Charge the battery
until it is 100% charged.
You can receive information about the status of the charging in
two ways:
When B-phone is on– send SMS from your mobile phone
to B-phone with command line „B-PHONE INFO";
When B-phone is off – during charging the red LED is on
(once in 4 sec the LED is on for 0.1 sec). When charging
is complete the red LED is on continuously.
During the first charging it is possible that the new battery is so
empty that the first 5 minutes there is no visual proof that the
4
charging has started. In such a case continue charging.
2. Installing the SIM card
Insert SIM card into „SIM card slot" (8)
[SIM card contains PIN code PIN „8888" if purchased
together with the device. In case you wish to use other
SIM card, you should change PIN code to „8888" with
the help of your mobile phone or your mobile network
operator. It is only with such PIN code that SIM card
will be ready for work and B-phone will be operational.].
3. Switching on
Press the „On/off button" (5) and hold it for 5 seconds until
the blue LED is active. B-phone may be preparing for operation
for up to 30 seconds.
4. Positioning
4.1. Place B-phone in one of two ways at your convenience:
In vertical position on flat surface;
Hang it up by using a strap and the eyelet on the top of
B-phone.
4.2. Position it in a way that "Movement sensor" (1) is direct-
ed at the sleeping baby.
4.3. Place it not further than 3 metres from the baby.
4.4. Set the level of sensitivity of sensors („Microphone" (3)
and „Movement sensor" (1)) of the B-phone according
to the distance from the baby and your considerations
about the scale of the detectable event.
5. Switching off
B-phone can be switched off in one of these ways:
Press „On/off button" (5) and hold it for 5 seconds until
the blue LED (2) starts to blink actively.
From the mobile Browser by sending the command „Off".
B-phone will turn off automatically if the battery charge level
is lower than 1%.
5
Advertisement
Table of Contents
