Advertisement
5. Turn on the power switch. When the SYS indicator on the front panel is blinking (once every two seconds), the device is
running and ready for configuration.
SYS
PWR
MGMT
MGMT
0
1
2
3
4
5
6
7
8
9
SVN5800
2
0/1
ALM
HDD
MODE
3
1
0
RST
CONSOLE
Front panel
GE0/0/0
GE1/0/4
3
Administrator
Intranet
• Two-Armed Mode: Connect one port to the router and another (uses the pre-NAT virtual gateway
address) to the firewall.
The SVN is connected to both the intranet (router or core switch) and Internet (the firewall).
SYS
PWR
MGMT
0
1
2
3
4
5
6
7
8
9
SVN5800
MGMT
2
0/1
ALM
HDD
MODE
3
1
0
RST
CONSOLE
GE1/0/4
Front panel
GE0/0/0
GE1/0/0
3
Administrator
Intranet
Default Configuration
Item
MGMT (management port)
Administrator account/password
Use the Web configuration wizard to complete basic network configuration.
1. Set the IP address to 192.168.0.2 (or any other in the range of 192.168.0.2 to 192.168.0.254) and subnet mask to
255.255.255.0 of the corresponding network interface on the administration PC.
2. Open a web browser and navigate to https://192.168.0.1:8443.
3. Enter the user name (admin) and password (Admin@123) in the login dialog box, and then click Login. You need to
change the user password as instructed after the first login.
4. In the Basic Network Configuration Wizard page that is displayed, select a networking mode according to your cabling
and click Next.
If the Basic Network Configuration Wizard page is not displayed, click the System tab and choose Wizard >
Basic Network Configuration Wizard on the left navigation tree.
5. Select and activate the License file and click Next. To obtain the License file, refer to
6. Configure the interfaces. In one-armed mode, configure the service interface (GE1/0/4 in the cabling figure); in two-armed
mode, configure the inside interface (GE1/0/0 in the cabling figure) and outside interface (GE1/0/4 in the cabling figure)
and click Next.
WSIC(Slot 2)
10
11
WSIC(Slot 3)
2
Router or Firewall
WSIC(Slot 2)
10
11
WSIC(Slot 3)
2
2
The MGMT port is numbered GE0/0/0 and assigned with IP address 192.168.0.1.
You can use the default account/password (admin/Admin@123).
SM-HDD-SAS300G-B
Rear panel
SM-HDD-SAS300G-B
Rear panel
Description
License Application Guide
2
INPUT OUTPUT
5
ON
XXXXXXXXXXXXXXXXXXXXXXXXXXX
OFF
~100-240V;50/60Hz;2.5A
4
INPUT OUTPUT
5
ON
XXXXXXXXXXXXXXXXXXXXXXXXXXX
OFF
~100-240V;50/60Hz;2.5A
4
.
SVN5800
4 HDD
5 PWR 6 PWR
1
SVN5800
4 HDD
5 PWR 6 PWR
1
Advertisement
