Table of Contents
Advertisement
slotted hole in pan.
4. Push down on seat to engage shoulder
bolt in slot and pull seat towards rear of
tractor.
5. Pivot seat and pan forward and as-
sem ble adjustment knob and fl at
washer loosely. Do not tighten.
6. Lower seat into operating position and
sit in seat.
7. Slide seat until a comfortable position
is reached which allows you to press
clutch/brake pedal all the way down.
8. Get off seat without moving its ad-
just ed position.
9. Raise seat and tighten adjustment
Seat Pan
Flat Washer
Adjustment Knob
CHECK BATTERY
1. Lift seat pan to raised position.
NOTE: If this battery is put into service
after month and year indicated on label
(label located between terminals) charge
battery for minimum of one hour at 6-10
amps. (See "BATTERY" in Maintenance
section of this manual for charging instruc-
tions).
Seat pan
Terminal
02602
NOTE: You may now roll or drive your
tractor off the skid. Follow the ap pro pri ate
instruction below to remove the tractor
from the skid.
TO ROLL TRACTOR OFF SKID (See
Op er a tion section for location and
function of con trols)
1. Press lift lever plunger and raise
2. Release parking brake by depressing
3. Place gearshift lever in neutral (N)
4. Roll tractor forward off skid.
Seat
5. Remove banding holding defl ector
TO DRIVE TRACTOR OFF SKID (See
Op er a tion section for location and
func tion of con trols)
Shoulder
Bolt
der stand and follow all in struc tions in the
Operation section of this manual. Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor is clear of other
people and objects.
1. Be sure all the above assembly steps
2. Check engine oil level and fi ll fuel tank
3. Sit on seat in operating position,
02464
4. Place gear shift lever in neutral (N)
5. Press lift lever plunger and raise
6. Start the engine. After engine has
7. Depress clutch/brake pedal into full
8. Slowly release clutch/brake pedal and
Label
9. Apply brake to stop tractor, set park-
Terminal
10. Turn ignition key to "STOP" position.
Continue with the instructions that follow.
9
at tach ment lift lever to its highest po-
si tion.
clutch/brake ped al.
po si tion.
shield up against tractor.
WARNING: Before starting, read, un-
have been com plet ed.
with gasoline.
depress clutch/brake pedal and set the
parking brake.
position.
at tach ment lift lever to its highest posi-
tion.
started, move throttle control to idle
position.
"BRAKE" position and hold. Move
gearshift lever to 1st gear.
slowly drive tractor off skid.
ing brake and place gearshift lever in
neutral position.
Advertisement
Table of Contents
