Rear Panel - FALCON THREE TV SDI User Manual

10.2 REAR PANEL

N°
CONTROL NAME
POWER SUPPLY UNIT
1
2 SERIAL PORT 1
2 SERIAL PORT 2
3 OUTPUT SDI
CONVERTER MODULE
(output)
4 OUTPUT SDI
CONVERTER MODULE
(Backup input)
Axel Technology srl www.axeltechnology.com
Switch with on/off light. The switch-power socket unit is fitted with a fuse drawer
that contains the power supply fuse and a spare one with the same
characteristics: 630 mA for 230V mains voltage.
Falcon Three TV SDI provides up to 3 opto-isolated serial ports to control the
device via remote control software. The "Axel Falcon Three Digital Audio
Processors Remoter" can be used to change also the nominal audio levels and
the port speed; the TAM (Target Address Manager) can be used to set or
change the values of the TCP/IP card.
Serial Port 1 can also be used to reprogram the firmware and to connect the
device to an external 56K analogue modem (for remote control using the
phone line). The Baud Rate can be set at 2400, 4800, 9600, 19200, 38400 Baud
from the menu on the front panel. Serial port 1
the front panel.
Serial Port 2 is used to control and manage the Falcon Three SDI TV. The
Baud Rate can be set at 2400, 4800, 9600, 19200, 38400 Baud from the menu
on the front panel.
This BNC is used to take the SDI digital television signal complete with
Processed Audio using the Falcon Three TV SDI Audio processor (Embedded
Audio) This is the main output of the SDI TV Video + Audio signal.
Secondary or Backup (bk) input of the Internal Re-Embedding module of the
Falcon Three TV SDI Audio Processor. It is the secondary input ONLY for the
SDI TV video signal. It is the secondary input of the Video Re-Embedding
module with the audio just processed by the Falcon Three TV SDI. By default it
is disconnected, but it is available.
FUNCTION
(RS-232) is also featured on
FALCON THREE TV SDI
GENERAL DESCRIPTION
ENG
15