AEG SANTO N 8 18 40-4 i Operating And Installation Instructions page 13

The temperatures in the refrigerator compartment and freezer co partment
cannot be independently regulated.
If you want the freeze fresh food rapidly, select setting „6", ensuring that
the temperature in the refrigerator compartment does not drop blow 0°C.
You should also promptly reset the temperature regulator to setting „3" or
„4".
Important!
High ambient temperatures (e.g. on hot summer days) and a cold setting on
the temperature regulator (position"5" to "6") can cause the compressor to
run continuously.
If this happens, turn the temperature regulator back to a warmer setting
(position "3" to "4"). At this setting the compressor will be switched on and
off as usual and automatic defrosting recommenced.
Control panel of freezer compartment
A. Pilot light (green)
B. Thermostat knob
C. Super control light (yellow)
D. Normal/Super push button
The control panel elements are: the thermostat (B) is also the on/off swit-
ch for the freezer compartment.
The green pilot light (A), which comes on when the mains voltage is avail-
ble. Switch the temperature regulator knob to a number position, the refri-
gerating unit automatically operates by system control. The yelloew pilot
light (C) comes on when the normal/super push botton is pushed.
Important note: if you operate the fast-freeze switch or adjust the tempe-
rature regulator, it may happen that your appliance's refrigeration motor
does not start immediately but only after some time. This does not mean
that your appliance has a fault..
38
1
2
6
3
5
4
A B C D
Place guide (A) on the inside part of
the furniture door, up and down as
shown in the figure and mark the
position of external holes. After
having drilled holes, fix the guide
with the screws supplied.
Fix cover (C) on guide (A) until it cli-
ps into place.
Open the appliance door and the fur-
niture door at 90°. Insert the small
square (B) into guide (A). Put
together the appliance door and the
furniture door and mark the holes as
indicated in the figure. Remove the
squares and drill holes with ø 2 mm
at 8 mm from the outer edge of the
door. Place the small square on the
guide again and fix it with the screws
supplied.
A
PR166
A
C
PR33
8mm
A
B
PR167
35