Download Print this page

Advertisement

Quick Links

DANGER
Ultraviolet radiation. Follow instructions. Avoid overexposure. As with
natural sunlight, overexposure can cause eye and skin injury and al-
lergic reactions. Repeated exposure may cause premature aging of the skin and skin cancer.
WEAR PROTECTIVE EYEWEAR; FAILURE TO MAY RESULT IN SEVERE BURNS OR LONGTERM
INJURY TO THE EYES. Medications or cosmetics may increase your sensitivity to the ultravio-
let radiation. Consult physician before using sunlamp if you are using medications or have a
history of skin problems or believe yourself especially sensitive to sunlight. If you do not tan
in the sun, you are unlikely to tan from the use of this product. Children, the elderly, or fair
skinned people who always burn easily and either never tan or tan minimally should not use
this equipment.
Contraindication: This product is contraindicated for use on persons under the age of 18
years. Contraindication: This product must not be used if skin lesions or open wounds are
present.
To use, lie down under canopy and pull down as far as adjustment will allow. Do not use with-
out clear plastic panel and wire grill in place. Untanned persons should not tan on consecutive
days during their first week of tanning. Never tan more than once a day. Tanning normally
appears after the first few sessions and maximizes after approximately four weeks. Tan once
or twice per week thereafter to maintain appearance. Persons already having a base tan may
begin at advanced levels corresponding to the extent of their base tan.
Skin Type:
I
Sensitive Skin
(Burns easily and severely and does not tan.)
II Light Skin
(Burns easily and severely and tans minimally.)
III Normal Skin
(Burns moderately and tans average.)
IV Dark Skin
(Burns minimally, tans easily and above average.)
RECOMMENDED EXPOSURE TIMES IN MINUTES
Level 1/Week 1
Skin Type:
1st-3rd Sessions
I
Sensitive
II Light
2
III Normal
3
IV Dark
4
MAXIMUM EXPOSURE TIME IS 12 MINUTES
New lamps emit approximately 10% more ultraviolet radiation during the first 50 hours of
operation. Recommended tanning times should therefore be reduced by approximately 10%
during that period.
WARNING: • Read these instructions before using this sunlamp product. • This product
should not be used on individuals who have had skin cancer or have a family history of
skin cancer. • Persons repeatedly exposed to UV radiation should be regularly evaluated for
skin cancer. • All persons in the room should wear protective eyewear when lamps are on.
Recommended eyewear: provided eyeshields or equivalent eyewear as defined under 21
CFR 1040.20. Other types of eyewear may not provide adequate protection. Failure to use
protective eyewear may result in severe burns or other eye injury. If discomfort develops,
discontinue use and consult a physician.
THE FOLLOWING LAMPS HAVE BEEN CERTIFIED FOR USE IN THIS EQUIPMENT:
SunFire® Plus Model F71/100W Bi-Pin
SunFire® Max Model FR71/100W Bi-Pin
Disconnect power cord before attempting to clean, relamp,
or engage in the maintenance of this product
THIS EQUIPMENT MUST BE EARTH GROUNDED.
This product is in conformity with performance standards for sun lamp products under 21
CFR PART 1040.20 and ANSI/UL Standard 482.
Electrical Requirements
Your sunbed operates from a 120V AC source. You should have a
NEMA 5-20R electrical outlet (below), on a dedicated circuit capable
of providing 20 Amp service, installed in the room in which you will
use the unit. We recommend installation by a professional electrician.
The outlet must be earth grounded.
Level 2
Level 3
Level 4
NOT RECOMMENDED FOR TANNING
4
7
10
6
9
12
7
10
12
20 AMP NEMA #5-20R
RECEPTACLE
32
Shock hazard.
Disconnect power before servicing or removing any pro-
tective covers.
Do not operate this device near water or while you are
wet.
Some medications may increase your sensitivity to ultraviolet light. It
is recommended that you consult a physician before using this sun-
bed if taking any medication or if you suspect that your skin might be
especially sensitive to sunlight.
Wear protective eyewear.
Failure to may result in severe burns or longterm injury to the eyes.
Air from the room is used to cool the sunbed. Maximum ambient room
temperature should be 80°F. Place your sunbed no closer than 6" from
any wall. Make sure nothing obstructs the airflow into the sunbed's
endcaps or out of the fan openings. A poorly ventilated room may
Level 5
cause the unit to become hot and cause discomfort to the user.
Unpacking and Inspection
12
12
Your sunbed comes in two cardboard cartons. Pull back the plastic
12
sheet and, with a helper, grasp the bench and pull it from the carton
bottom, leaving the plastic wrap and the carton packaging. Do not try
to lift the unit with the plastic still on as it may slip. Do the same with
the canopy.
The canopy box contains the canopy, a pair of gas springs, and the as-
sembly hardware. The bench box contains the bench and stand legs.
Inspect the items and make sure they are free from any visible damage.
Report the extent of any damage to the transportation company.
Hardware Inventory
Shoulder Bolt
Quantity 2
Flanged Sleeve Bushing
Quantity 2
Nylon Flat Washer
Quantity 2
3/8" Washer, Black
Quantity 2
3/8-16 Locknut, Black
Quantity 2
DANGER
DANGER
WARNING
CAUTION
(Plus a small pillow and eyewear)
Hex (Allen) Wrench
Quantity 1
You Will Need:
#2 Phillips
Screwdriver
9/16" Wrench
10199B

Advertisement

loading

Summary of Contents for Sunfire SunFire 32

  • Page 1 THE FOLLOWING LAMPS HAVE BEEN CERTIFIED FOR USE IN THIS EQUIPMENT: Hardware Inventory (Plus a small pillow and eyewear) SunFire® Plus Model F71/100W Bi-Pin SunFire® Max Model FR71/100W Bi-Pin Shoulder Bolt Disconnect power cord before attempting to clean, relamp,...
  • Page 2 Assembly Procedures Lay the bench upside down on the floor. Locate the two stand legs. Use the same bolts and washers to attach the stand legs. Make sure the Remove the six bolts and washers bolts are secure. installed in the bench. Turn the bench over and attach the canopy as shown.
  • Page 3 The following lamps have been certified for use in this equipment: bottle to wet the area thoroughly. Allow to remain wet for 30 seconds SunFire® Plus Model F71/100W Bi-Pin and then wipe the surface dry. Then disinfect as described above.
  • Page 4 SUNFIRE INDUSTRIES will advise the Purchaser of the nature of the problem and the cost to yond the range of normal usage, or by accident, fire or other hazard. Repair or replacement of a the Purchaser based on the proration of the defective system or component.