Table of Contents
Advertisement
Fitting and removing the towing eye
Use the towing eye if the car shall tow another
vehicle. The towing eye is screwed into a threa-
ded socket behind a cover on the right-hand
side of the rear bumper.
NOTE
If the car is equipped with a towbar, there is
no rear mounting for a towing eye.
Fitting the towing eye
Take out the towing eye from the foam block
under the floor in the cargo area
The shape and location of the foam block may vary depending on car model.
7
Remove the cover - press on the marking
with a finger and, at the same time, fold out
the opposite side/corner using a coin or sim-
ilar.
> The cover pivots around its centre line and
can then be removed.
7
.
STARTING AND DRIVING
3. Screw the towing eye right in until it stops.
Screw the eye in firmly. For example, thread
through the wheel bolt wrench* and use it as
a lever.
IMPORTANT
It is important that the towing eye is firmly
screwed into place - right in until it stops.
Removing the towing eye:
–
After use, unscrew the towing eye and return
it to its place.
Finish by refitting the cover onto the bumper.
Related information
•
Towing (p. 474)
•
Recovery (p. 476)
•
Tool kit (p. 549)
475
* Option/accessory.
Advertisement
Table of Contents
