Table of Contents
Advertisement
ATTENTION
While installation process, heat-emitting plate can be touched only in cotton
gloves. In case it is dirty it showed be cleaned with alcohol.
1.
Take the heater out of the package and put it on a horizontal surface heater plate down.
2.
Define the place for the heater and mark the point of the screw ring (for
fittings according to the scheme.
3.
Screw in the ring and hang the heater with the help of the chain (the length of the chain
can be regulated for
should fit into the holes and screw the pegs (for industrial).
4.
Before switching on, the heat-emit
5.
The flex must consist of three wires and have the diameter complying with electrical
power. (we recommended polyvinil 3x1,5-2,5)
6.
Attach the end of the flex to terminals on the heater taking into account polarity marked
on the ends of the flex.
7.
Heater connection to the stationary power point with thermoregulator is strictly according
to the scheme.
8.
Thermoregulator should be placed 1,5 m., above the floor. Do not place it in the zone of
direct rays or in the draught to avoid malfunctions.
The end of the chain with a wide link is placed into a hole on the back part of the heater
The heater is fixed on the chains to the screw ring which is screwed into the ceiling.
5
6.Installation
!
"ПИОН")
. Place the heater between the fittings so that the pegs
ting plate should be cleaned with alcohol.
Installation scheme for "ПИОН"
"ПИОН")
or corner
Advertisement
Table of Contents
