Table of Contents
Advertisement
1.5
Strongly prohibited to touch the surface of working heater to avoid burns
2.5
Use heater only for its purpose.
3.5
Strongly prohibited to make any changes in the heater construction
Any changes will cancel guarantee
4.5
Install the heater as said in chapter 6 and 7.
5.5
The heater can be used to warm up dwellings and industrial premises, but for those prone
to explosions (A, B categories)
6.5
The heater is permitted in wet premises under the condition water does not get
on its surface.
7.5
Do not dip the heater into water or other liquids.
8.5
Do not touch the heater until it is cool.
9.5
The power flex must not touch hot heater surfaces.
10.5
Heater exploitation is not recommended without earth connection (Chapter 7),
electrical protection against high voltage and short circuit current is desirable.
11.5
Electrical connection is recommended to be fulfilled by qualified specialists (Chapter 7).
12.5
Connect the heater only to the source of alternating current with voltage
13.5
Combined exploitation of the heater together with programming devices or timer
which turns on the heater automatically even if it is covered or incorrectly installed
is forbidden (Chapter 6).
14.5
Heater connection to the power point should use a flex and a plug.
15.5
Use brass wire not less than 2,5 sq. mm., in diameter for connection.
16.5
If you connect the heater in a wrong way you lose your guarantee service !
1
7.5
It is forbidden to hang any objects on a heater, or cover it.
18.5
After installing the heater check its reliability attaching the weight of 12 kg.,
to the centre.
19.5
Do not repair the device yourself ! It should be done by the service centre specialists
only.
20.5
To repair the heater only original spare parts can be used.
5.Safety measures
!
!
!
220/230
V.
4
Advertisement
Table of Contents
