Related Manuals for Karel PG100-CU
Summary of Contents for Karel PG100-CU
- Page 2 Failure in fulfilling those requirements may result in vital hazards! PG100-CU TTKK - REVAAA 17/07/2003 KAREL may modify the content of this guide because of any improvement or addition without any notice. The products may have some differences from the functionality...
- Page 3 Chapters in this guide have been prepared in order to present detailed technical TECHNICAL INTRODUCTION:....................1 information to people who need hardware-based information about the PG100-CU INTRODUCTION TO THE PG100-CU UNIT:............1 Internal Pager System Control, and instructing them for installation of the PG100-RF.
-
Page 4: Technical Introduction
(PG100-RF) by utilizing a PG100-CU control unit, so that COMPATIBILITY the coverage area can be extended. The PG100-CU unit is used with the PG100-RF local transmitter units. The PG100-CU unit transfers the call information, which is transmitted... -
Page 5: Installation
Locations of the electrical outlet and DTB04 if there is one should be taken into consideration. The PG100-CU unit is fed on -48 VDC. The product DTB04 can be used for feeding. • Locations of the PG100-RF transmitters should be taken into consideration. - Page 6 Connection to the MS series exchanges can be made over the KTS interface and to the DS series exchanges over either KTS or RS422 interfaces. Signal assignments for the The PG100-CU unit starts to operate after its connections have been completed. KTS/RS422 and RS232 connectors have been shown in the figure below. Tips specified as “NC”...
- Page 7 TECHNICAL REFERENCE AND USER’S GUIDE REVAAA INTERNAL PAGER SYSTEM CONTROL UNIT...
- Page 8 TECHNICAL REFERENCE AND USER’S GUIDE REVAAA INTERNAL PAGER SYSTEM CONTROL UNIT...
- Page 9 TECHNICAL REFERENCE AND USER’S GUIDE REVAAA INTERNAL PAGER SYSTEM CONTROL UNIT...