Subscribe to Our Youtube Channel
Related Manuals for Foxconn WIN-B2
Summary of Contents for Foxconn WIN-B2
- Page 1 COMPANY CONFIDENTIAL WIN-B2 Bluetooth Module User Manual Rev. 1.1 Prepared by Reviewed by Approved by Gallon Tao...
- Page 2 COMPANY CONFIDENTIAL Index 1. REVISION HISTORY..............................3 2. INTRODUCTION ................................4 3. PRODUCT SPECIFICATION .............................5 4. PRODUCT REQUIREMENTS AND CHARACTERISTIC..................6 5. MECHANICAL DRAWING ............................6 6. REGULATORY INFORMATION..........................7...
-
Page 3: Revision History
COMPANY CONFIDENTIAL 1. Revision History Date Change Note Note 2011-02-22 Initial Release Correct typo in page 5, section 3.1, correct “WiFi” to 2011-02-26 “Bluetooth”... - Page 4 Project Name: Bluetooth 4.0 +EDR(Low Energy support) module This documentation describes the product specification of the Bluetooth 4.0 module. It is a confidential document of Foxconn. 2.1 Scope This Bluetooth module is available in the 2.4-GHz ISM band, it is compatible with Bluetooth specification v4.0.
- Page 5 COMPANY CONFIDENTIAL 3. Product Specification 3.1 Bluetooth RF Specification Bluetooth Standards v4.0 (Basic Rate + EDR + LE) Operating Frequency 2.400 – 2.4835 Data Rate Basic Rate: 1Mbps Enhanced Data Rate: 2Mbps, 3Mbps Low Energy: 1Mbps Modulation Schemes GFSK(1Mbps); DQPSK(2Mbps), 8DPSK(3Mbps); LE GFSK(1Mbps) Transmitter Output Power Transmitter Output Power: -6dBm~ +4dBm (Class 2 Specification)
- Page 6 COMPANY CONFIDENTIAL 4. Product Requirements and Characteristic 4.1 Hardware Characteristic Form factor 26.3X17(mm ) module with 2X9 pin board to board connector Host Interface USB 2.0 (Full Speed) 4-layer single side Antenna &RF connector One printed Antenna, One W.FL RF connector for testing purpose 4.2 Hardware Architecture This Bluetooth module design is based on Broadcom BCM20702 chipset, which is a highly integrated single chip solution for Bluetooth 4.0+EDR.
- Page 7 Labeling Hon Hai Precision Bluetooth 4.0 module WIN-B2 labeled as below. FCC ID: MCLWINB2 The proposed with FCC ID label format is to be placed on the module. If FCC ID is not visible when the module is installed into the system, “Contains FCC ID: MCLWINB2”...
Need help?
Do you have a question about the WIN-B2 and is the answer not in the manual?
Questions and answers