Table of Contents
Advertisement
S Lift up tip of guide bar to check for sag. Re-
lease tip of guide bar, then turn adjusting
screw until sag does not exist.
S Tighten chain brake nuts securely with the
bar tool.
Chain Brake
Nuts
S Use the screwdriver end of the bar tool to
move chain around guide bar.
S If chain does not rotate, it is too tight.
Slightly loosen chain brake nuts and loos-
en chain by turning the adjusting screw.
Retighten chain brake nuts.
KNOW YOUR SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
CHAIN SAW. Compare the illustrations with your unit to familiarize yourself with the location of the
various controls and adjustments. Save this manual for future reference.
Chain Adjustment
Front Hand Guard
Tool
(Bar Tool)
Chain
Bar Sprocket
Hole
Cylinder Cover
Throttle
Lock- -out
Rear
Handle
Throttle
Trigger
Choke/Fast Idle Lever
ON/STOP SWITCH
The ON/STOP SWITCH is used to stop the
engine.
THROTTLE TRIGGER
The THROTTLE TRIGGER controls engine
speed.
S If chain is too loose, it will sag below the
guide bar. DO NOT operate the saw if the
chain is loose.
NOTE:
the weight of the chain does not cause it to sag
below the guide bar (with the chain saw sitting
in an upright position), but the chain still moves
freely around the guide bar.
WARNING:
with a loose chain, the chain could jump off the
guide bar and result in serious injury to the op-
erator and/or damage the chain making it un-
usable. If the chain jumps off the guide bar, in-
spect each drive link for damage. Damaged
chain must be repaired or replaced.
OPERATION
Front Handle
Muffler
Bar Oil
Fill Cap
Starter Housing
Adjusting
Screw
Chain Brake Nuts
Chain Brake
THROTTLE LOCK ---OUT
The THROTTLE LOCK- -OUT must be
pressed before you can squeeze the throttle
trigger. This feature prevents you from acci-
dentally squeezing the trigger.
8
The chain is tensioned correctly when
If the saw is operated
Starter Rope
ON/STOP
Switch
Fuel Mix Fill Cap
Direction
of Chain
Travel
Guide Bar
Advertisement
Table of Contents
