Download Print this page

Cartft CTFPND-9 Quick Start Manual

Advertisement

Quick Links

Product introduction

CTFPND-9 has many features (wifi, BT, GPS, 3G, back camera, front camera, RFID, lightsensor,
gyroscope, accelermeter)
Highlights:
3G – pls insert the SIM card when the device if complete off
front camera – there are 6 IR LED around the camera. if you enable the flash function in front camera,
then you will see the IR LED is on. In this case, the picture will be in black and white
Pls move right to open the
cover, you will hear "click"
sound, it is normal
All rights reserved. No part of this work may be reproduced or copied in any form or by any means (graphic, electronic, or mechanical, including photocopying,
recording, recording taping, or information and retrieval systems) without the written permission of the copyright owner

Quick Start Guide

Micro usb for connecting to PC or charging
Pls cover it well in order to ensure the waterproof
performance
On/off button
Pls move upward to open the
cover, you will hear "click"
sound, it is normal
SD card slot, SIM card slot and
reset button
Screw hole is available if you
want to lock the cover
Pls cover it well in order to
ensure the waterproof
performance
1

Advertisement

loading

Summary of Contents for Cartft CTFPND-9

  • Page 1: Quick Start Guide

    Quick Start Guide Product introduction CTFPND-9 has many features (wifi, BT, GPS, 3G, back camera, front camera, RFID, lightsensor, gyroscope, accelermeter) Highlights: 3G – pls insert the SIM card when the device if complete off front camera – there are 6 IR LED around the camera. if you enable the flash function in front camera, then you will see the IR LED is on.
  • Page 2 Direction of SIM card and SD card All rights reserved. No part of this work may be reproduced or copied in any form or by any means (graphic, electronic, or mechanical, including photocopying, recording, recording taping, or information and retrieval systems) without the written permission of the copyright owner...
  • Page 3 Interface 1. There is TTL serial port (Tx/RX) or OTG from 10 pin usb connector 10pin usb connector pls see the above schematics of our USB connector in our PND, it is 10 pin connector. Pin 4 and 6 can be used for USB or TTL serial interface (Rx/Tx) and Pin 8 is ID pin which is used to distinguish for USB or serial interface.
  • Page 4 2. There are Rs232 interface and OTG from cradle. Highlights: OTG port from device (10pin usb connector) and cradle are sharing same pins. Only 1 OTG interface can be used. Usb connector for OTG or charging This cable can be customized when you placed order For sample, it will be 12 pins connector, pls see below or pins assignment...
  • Page 5: Device Installation

    Device installation There are few options 1. Directly attach mount to device (no cradle in this case) 2 screw hole at the back Pls use M4 18mm screw 2. Cradle attached to car mount with different screw length 2 screw hole at the back Case 1 –...
  • Page 6 Serial ports, software interface two serial ports are available one the device :  one shares the the USB data pins of the mini A/B USB connector. Only TX and RX pins are available, voltage is TTL 3.3V.  one is on the Pogopin interface (pins 3, 5, 6 and 7). TX, RX CTS and RTS are available, voltage is RS232.