Operation - Poulan Pro 545047535 Instruction Manual

3. Using bar tool, roll chain around guide bar
to ensure all links are in bar groove.
4. Lift up tip of guide bar to check for sag.
Release tip of guide bar, then turn ad-
1
justing screw / turn clockwise. Repeat
4
until sag does not exist.
Adjusting Screw - -
5. While lifting tip of guide bar, tighten bar
nuts securely with the bar tool.
Bar Nuts
KNOW YOUR CHAIN SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
CHAIN SAW. Compare the illustrations with your unit to familiarize yourself with the location of
the various controls and adjustments. Save this manual for future reference.
Chain
Front Hand Guard
Adjustment Tool
(Bar Tool)
Chain
Bar
Bar Oil Fill Cap
Sprocket
Hole
Cylinder Cover
Throttle
Lockout
Rear
Handle
Throttle
Clutch Cover
Trigger
ON/STOP SWITCH
The ON/STOP SWITCH is used to stop the
engine.
6. Use the screwdriver end of the bar tool
to move chain around guide bar.
7. If chain does not rotate, it is too tight.
Slightly loosen bar nuts and loosen
chain by turning the adjusting screw
turn counterclockwise. Retighten bar
nuts.
1
/ Turn
4
8. If chain is too loose, it will sag below the
guide bar. DO NOT operate the saw if
the chain is loose.
WARNING:
with a loose chain, the chain could jump off
the guide bar and result in serious injury.

OPERATION

Muffler
Starter Housing
Chain
Brake
Adjusting Screw
Chain
Catcher
Bar Nuts
THROTTLE TRIGGER
The THROTTLE TRIGGER controls engine
speed.
8
If the saw is operated
Front Handle
Starter Rope
ON/STOP
Choke/
Switch
Fast Idle
Lever
Primer Bulb
Fuel Mix Fill Cap
Chain
Direction
of Travel
Guide Bar
1
/
4