MAPIR Survey3 Quick Start Manual page 3

Inserting / Removing the Battery
1. Open the battery cover and insert the battery (normally a battery is
already installed).
3. Charging the battery by connecting the camera to a computer or
other USB charging adapter using the included USB cable. The camera
status light turns on during charging.
Note:
Using wall chargers marked: output 5V 1A. If you don't know the
voltage and current of your charger, use the included USB cable to
charge the camera from your computer or a power bank.
Inserting / Removing Memory Cards
To Insert the microSD Card:
SD
Slide the memory card into the
card slot with the label facing
the back of the camera.
When fully inserted, the card
clicks into place.
Note:
The microSD card is sold separately. The microSD card must have
a Class-10 or UHS-I rating and the capacity up to 128GB.
04
To Remove the microSD Card:
SD
Place your fingernail against the
edge of the memory card and
lightly press it further into the
camera.
The card springs out far enough
to be removed.
Getting Started
Charging the Battery
Press to unlock the battery
cover, then push it out.
Status LEDs
There are 4 LEDs on the camera, the default status is showed as below,
and also user can turn on or off LED in the menu.
Status
Front LED 1
The camera is powered on
Solid Red
and in standby mode
The camera is recording Flashing Red
In photo mode
/
A photo taken
/
Battery charging
Solid Red
Battery charging
/
completed
Firmware upgrading
/
Rechargeable battery
LED Activity
Front LED 2 Top LED Back LED
/
Solid Red Solid Red
/ Flashing Red Flashing Red
Solid Green Solid Red
Solid Red
Flashing Green
Solid Red Solid Red
Once
Flashing Red Flashing Red
/
Solid Green
/ /
Flashing Green Flashing Red Flashing Red
05