Advertisement
Orange Pi mini 2 User Manual
connector for anyone who wants to plug the Orange Pi Mini 2 into
a wired network.
5. Finally, on the very left of the bottom edge is the DC power
connector. Plug in a regulated power supply that is rated at 5V ±
5% and at least 1500mA (or 2.0A). Any number bigger than 1500
mA will also work.
Note : Avoid using OTG USB as power input, because it does not
work. Only the DC power can make the board
If all goes well, the Orange Pi Mini 2 will boot in a few minutes. The
screen will display the OS GUI(Graphical User Interface). The first
boot of a new OS can sometimes take a long time. Be patient!
Subsequent boots are usually much quicker.
Step4: Shut down your Orange Pi Mini 2
You can use the GUI to shut down the Orange Pi Mini 2 safely.
Also you can run the command in the terminal:
sudo halt
or
sudo shutdown –h.
This will shut down the PI safely, (just use the power key to turn off might
damage the TF-cards file system). After that you can press the power key
for 5 seconds to turn it off.
If all is well ,so you can use orange pi Mini 2 now.
GPIO specification
Orange Pi Mini 2 40-pin GPIO
Orange Pi Mini 2 has a 40-pin GPIO header that matches that of the Model A and Model
B Raspberry Pi. Following is the Orange Pi Mini 2 GPIO Pinout:
www.orangepi.co.kr
Daehosemicon CO., Limited
work.
www.daehosemicon.co.kr
Advertisement
