AbiSee Eye-Pal SOLO LV Quick Reference

Quick Reference For Eye-Pal Solo
SOLO LV allows you to read printed text and magnify small objects. There are
three ways Solo LV can be used to read printed material.
Front Panel Buttons – conveniently placed
Motion Activated – the no button solution
Keypad – controls at your finger tips

Front Panel:

Power - the green square button all the way to the right is used to turn the
device on as well as off.
Pause/Resume reading - the white circle button on the left side of the knob on
the front panel allows you to pause and resume reading. If this circle button is
held down for 3 seconds it will enable/disable the use of hand motions.
Read Previous Sentence - the red square button all the way to the left is used
to read the previous sentence. Again this button may be pressed as many times as
you need to go back to a certain sentence. If this red button is held down for 5
seconds it will restart the software.
Reading Speed - to the right of the knob are two white square buttons. These
square buttons are lined up vertically one on top of the other. The top button will
increase the reading speed, while the bottom button will decrease the reading
speed.
Volume - may be changed by turning the knob in the middle of the front panel of
the device.
Restarting - if device freezes press the red button for 5 seconds. You will hear
the device say "restarting".
Motion Activated Controls:
(By default this is disabled)
To enable motion activated controls press the white circle on the front panel and
hold down for 3 seconds.
Pause/ Stop Reading - move your hand slowly above the printed material from
left to right.
Resume Reading - move your hand slowly above the printed material from left to
right
1