Honeywell CS071AE User Manual page 5

USE & OPERATION (CONTINUED)
CLEANING THE CARBON DUST FILTER* AND HONEYCOMB COOLING MEDIA
The appliance is supplied with a Carbon Dust Filter* &
Honeycomb Cooling Media.
The Carbon Dust Filter* and Honeycomb Cooling Media are
located inside the Rear Grill. See Figure 1 for instructions on
how to remove them from the unit for cleaning and
maintenance.
Do not run the unit in COOL mode with stale water in the
tank. You must empty the water tank and refill with fresh
water, especially if the tank has not been cleaned in a long
time.
The cleaning frequency for the Honeycomb media depends
on local air and water conditions. In areas where the mineral
content of water is high, mineral deposits may build up on
the Honeycomb Cooling Media and restrict air flow.
Draining the water tank and refilling with fresh water at least
once a week will help reduce mineral deposits. If mineral
deposits remain on the Honeycomb Cooling Media, the
media should be removed and washed under fresh water.
The media should be cleaned every two months or sooner,
depending on your needs.
For best results allow the Honeycomb Cooling Media to dry
after each use by turning off the cool function 15 minutes
before turning the unit off.
Figure 1:
Removing the Carbon Dust Filter*/ Honeycomb Cooling Media:
1. Remove one screw from the Rear Grill of the Air Cooler.
2.
Carefully slide out the rear grill from the cooler.
3. Slide out the Carbon Filter* and clean with water.
4. Pull out the Honeycomb Cooling Media.
5. Replace or clean media with water and a damp cloth as
needed.
WARNING: DO NOT operate the Air Cooler when the
Rear Grill is removed from the Air Cooler, or if there is a
loose-fitting Rear Grill. Doing so can cause serious injury
or dangerous electrical shock.
*Applicable for models with Carbon Dust Filter only.
EN 4
Honeycomb
Rear
Cooling Media
Grill
Carbon Dust
Filter
Screws