Land Pride PATRIOT FDR1648 Operator's Manual page 30

Section 5: Maintenance & Lubrication
Do Not Overfill
IMPORTANT: This implement is shipped with a
vented dipstick packaged in the Operator's Manual
bag and should have been installed in the gearbox by
your dealer. Please consult your dealer if vented
dipstick was not included.
NOTE: Use a suction or siphon pump to drain
gearbox of oil when there is not an oil drain plug.
26
Table of Contents
30215
Gearbox
IMPORTANT: Do not overfill gearbox with oil! Oil will
expand when hot! Make sure implement is level and oil
is cool before checking oil level.
Method 1: With a wrench, unscrew top vented dipstick
(#1). Wipe oil from dipstick and screw dipstick in without
tightening. Unscrew dipstick and check oil on dipstick. If
below bottom level mark, add recommended gear lube
through dipstick hole until oil reaches top mark on
dipstick. Reinstall vented dipstick and tighten.
Method 2: Remove side oil plug (#2). If oil is below
bottom of plug hole, add recommended gear lube
through top dipstick hole until oil flows out of side plug
hole. Reinstall and tighten side oil plug (#2) and vented
dipstick (#1).
Type of Lubrication: 80-90W EP Gear Lube
Quantity = Fill until oil reaches top mark on dipstick or
begins to flow out side plug hole in gearbox.
Wheel Support Busings & Wheel Bearings
Type of Lubrication: Multi-purpose Grease
35788
Bearing in Blade Spindle Hubs
Type of Lubrication: Multi-purpose Grease
35787
As
Required
25
Hours
25
Hours
10/26/17