Page 1
This monitor is equipped with Mini USB port, signals and power is obtained from standard Warning! USB 2.0 or USB 3.0 port. Do not expose this unit in the rain or moisture environment to damage the monitor. PRECAUTIONS Do not use the monitor near water. Do not place the monitor on an unstable cart, stand, or table.
I. Introduction: P150TR is a color TFT LCD monitor, with compact and ecological design. P150TR is an USB input Monitor with EETI controlled resistive touch screen and USB Hub Features 15 inch diagonal screen with native display resolution 1024 * 768.
Installation: Installing the DisplayLink USB Graphics Software (for Windows OS) Install Displaylink Driver: Insert CD, Double click CD, the Installation menu shown as below.
Page 5
Click Installation The Displaylink software end user Licence agreement shown as below: Click I Accept, the Displaylink Core Software installs Displaylink USB Graphic software installation will complete without notification. Note 1: On some computers you may need to reboot before you can use your Displaylink enabled device Note 2: For operating system other than Windows, please visit DisplayLink website: http://www.displaylink.com/support/downloads.php...
Page 7
Select the set up type, don’t tick the box if PS2 interface is not required, Click “Next> RS232 interface driver installed is default, please click Next>...
Page 8
You can select to do Touch screen calibration after system boot up or not Default setting is” None” Select to use Multi-Monitor system, then press Next>...
Page 9
Choose destination location, default folder location shown as below. Press Next> As Figure shown below, please press Next> to complete installation...
Control Buttons/Connectors Power After USB driver is installed, connect monitor to PC via USB cable. ON/OFF Press power key to turn on /turn off the display Blue LED indicate power on Press this key will increase screen brightness Down Press this key will decrease screen brightness Rear side connection: ④...
III. Power supply: P150TR need to use external AC-DC adaptor Wall mount type power adaptor, Input: 100~240AC 0.9A, Output: 12Vdc 3.0A Power consumption Normal : <18W typ. (with keyboard, mouse connected). Power save / off : 2W max. (Down-stream ports not connected) IV.
VIII. Mechanical dimension: IX. EMC Warning Statement: FCC Class A Warning This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
600:1(typ.) Response Time 8 ms (typ.) Viewing Angle V: 160 , H: 160 Brightness P150TR: 200 cd/m (typ.), at 80% transmission rate touch panel Mini USB B type Input Video signal (With 1.8 meter USB cable) Input Frequency H: 48.363kHz ; V:60Hz Power supply Power consumption: <18W typ.( (with keyboard, mouse...
Need help?
Do you have a question about the P150TR and is the answer not in the manual?
Questions and answers