Viking CTG-2A Product Manual page 9

C. CL-DMD2 / CL-DMD4 Double Mount Installation
* Single or Double
Gang Electrical Box
(not included)
* Important: Single or Double Gang Electrical Box
Use one that can support a minimum of 50 lbs.
1. Install Metal Mounting Bracket - Screw the metal mounting bracket to the wall or ceiling in which the clock is being installed
using the four (4) 6-32 x1" screws supplied in the assembly kit. Use the inner four holes to mount to the gang box. Use the outer
four holes to mount anchors to the wall (anchors not supplied in kit).
Notes: If using a plastic gang box, a ground wire must be routed through the gang box and into one (1) of the four (4) Metal
Mounting Bracket screws in order to provide ground to the Metal Mounting Bracket. Note: The Metal Mounting Bracket MUST
be secured by both the screws going to the gang box AND the anchors going into the wall.
2. Feed Wiring Through Base and Pole - Take the wire coming from the gang box and feed it through the supplied mounting pole
and base.
3. Snap and Screw Base to Metal Mounting Bracket - With the wire now fed through the base and the pole, snap the base to
the metal mounting bracket by first making contact with the lip in the upper side of the base and the metal mounting bracket.
When the base has been snapped onto the bracket, take the two (2) 6-32 x 1/2" pan head screws supplied in the assembly kit
and screw them into the two holes on the underside of the base to secure the base to the Metal Mounting Bracket.
4. Mount Clock Housings to Pole - Feed the wiring from the end of the mounting pole into the hole in the middle of each clock
housing. Align each housing, one at a time, with the four holes on the mounting pole and screw from the inside of the housing
into the pole using the four (4) 8-32 x 7/16" screws supplied in the assembly kit (4 screws per clock).
Note: End caps from one side of each clock must be removed to mount both clocks to the mounting pole. Remove one end cap
from each clock from the side in which the mounting pole enters the clock.
5. Screw Both Housings Together - Using the two (2) self tapping, 6-19 x 7/16" screws supplied in the assembly kit, screw both
back sides of the clock housings together (2 screws per clock).
6. Plug and Secure Wiring - Loosen and slip excess wiring through provided wire clamp (comes attached to each housing) and
tighten the clamp. After securing excess wiring, plug the jack at the end of the wiring into the appropriate jack on the back of the
display board. Perform this task for both clock housings.
7. Mount Display Board to Housing - Using the four (4) self tapping, 6-19 x 1/2" flat head screws supplied in the assembly kit,
take the display board and screw it to the front side of the clock housing (4 screws per clock).
8. Snap on Filter - Take the red filter bezel and snap it on to the front side of each clock housing.
9. Snap on Frame - Take the gray frame and snap it on to the front side of each clock housing.
9