Advertisement
Please note: care should be taken to ensure that testing does NOT damage the equipment in any way.
Cleaning
If the card becomes dirty it can be cleaned with compressed air. Do NOT use solvents, cleaners, or liquids to clean
the board. Caution must be exercised when cleaning the board in order to prevent damage from ESD (electrostatic
discharge).
6. Enclosure Specifications
The UI card is always mounted in the UIX enclosure.
Specifications
Dimensions
Hazloc Rating
Mounting
Enclosure Construction
Operating Temperature
Storage Temperature
Please note: the enclosure is NOT a Class I Div 2 enclosure; the UI card and the enclosure together allow the rating.
Any additional components will affect the rating and should therefore be taken into consideration.
Important Safety Information
Before installing the PF3100 User Interface (UI) card, please review the list of warnings below. Failure to observe
the following warnings may result in death, electrocution, property damage, product damage, and/or government
fines.
WARNING: Explosion Hazard
➢
Do not disconnect while circuit is live unless area is known to be non-hazardous or equivalent.
➢
Substitution of components may impair suitability for specified zones.
➢
Do not service unless the area is known to be non-hazardous.
➢
Do not open when energized.
➢
Do not plug in or remove connectors unless the area is known to be non-hazardous; this includes the USB, SD
card, and battery.
➢
Installation and use must conform to the directions in this guide.
PROFIRE
1.855.776.3473
solutions@profireenergy.com
PF3100 User Interface Card Product Manual
UIX Enclosure
Height 30.9cm (12.15 inches)
Width 23.4cm (9.23 inches)
Depth 13.4cm (5.28 inches)
Class I Div 2, IP66
Channel Bar or Direct Mount
Poly Painted Steel
-40°C (-40°F) to 60°C (140°F)
-40°C (-40°F) to 60°C (140°F)
Page 8 of 9
Advertisement
