Table of Contents
Advertisement
9
Reset SavvyLevel to Factory Default
CAUTION! EXCEPTING THE PUSHBUTTON, PLEASE DO NOT TOUCH ANY PART OF
THE PRINTED CIRCUIT BOARD, AS THIS MAY DAMAGE THE DEVICE.
If you forget your passkey you can always reset the SavvyLevel device to its factory default setting.
To do this you need to gain access to your SavvyLevel device.
1. Remove the lid by gently squeezing it as shown in Figure 9.
2. Locate the reset button (Figure 10 – 1) and carefully press and hold the button until you see a
green LED (Figure 10 – 2) flash repeatedly.
3. When the green LED returns to a quick flash every 5 seconds, the device is reset.
Default settings are:
Device Name: SavvyLevel
Passkey:
4. Launch your SavvyLevel app on your Smartphone and follow the procedures in section 6
Connecting and Personalizing. Remember that the passkey is '000000'.
Don't forget to personalize your device again.
10 Troubleshooting
Q – I get very poor Bluetooth signal range.
A – The most likely cause is that there are too many signal obstructions (metallic objects) in a direct
path, between your Smartphone and your SavvyLevel device.
Try to operate your Smartphone in a different location. Try opening hatches or window coverings in
your caravan where your SavvyLevel is installed. Try to place your SavvyLevel in a better location.
Refer to the 'Installation Guide' sheet.
Q – My compass does not work.
A – Check that your SavvyLevel is not too close to magnetic or ferrous objects. Refer to the
'Installation Guide' sheet.
Figure 9
000000
3
Figure 10
6
1
2
Hide quick links:
Advertisement
Table of Contents
