JRC JRL-710AP3R User Manual page 7

Name
⑤ ANT1
⑥ ANT2
⑦ CONSOLE
⑧ 10/100BASE-T
⑨ DC +5V
⑩ CLR
２．Login
The IP address initial value of wireless LAN is set as "192.168.1.1/24."
Here, the login method in case the IP address of this equipment is
"192.168.1.1/24" is shown.
Please read a user's manual about the command for setting change,a
display, and an examination of this equipment.
①Login
PC which logs in to this equipment is prepared.
The IP address of PC is changed into "192.168.1. x/24" so that PC
can communicate with this equipment. However, the value of "x" is
2 to 254.
②PC If a setup of PC is completed, this equipment will be connected
with PC by cable. If it connects with PC normally, the "E-LINK" lamp
will light up.
User account
（1）
The following user names and passwords are set up in the initial state.
Please change a password at the time of the first login for security
protection.
User name
admin
user
It is a connector which connects an antenna.（Main）
It is a connector which connects an antenna.（Sub）
It is a connector which connects maintenance PC.
It is a connector which connects Ethernet.
A power supply is connected and a power supply is
supplied to equipment.
This connection is unnecessary when supplying a power
supply by PoE.
It is a switch which initializes a setup.
The power supply of this equipment is switched on
pushing the "CLR" button.
If it is continuing pushing the "CLR" button, the "PWR"
lamp will change from "green" to "orange" for 1 second.
Then, equipment returns to initial setting.
Password
admin Setting change / setting display
user Setting change (only password) / setting
display
Remarks
Authority
7/12