Table of Contents
Advertisement
missing or damaged, contact your local distributor. Also be sure
that you have all the necessary cabling before installing the
Wireless Repeater. After installing the Wireless Repeater, refer to the
web-based configuration program in "Configuring the IEEE
802.11g Wireless Repeater" on page 20 for information on
configuring the Wireless Repeater.
Package Contents
After unpacking the Wireless Repeater, check the contents of the
box to be sure you have received the following components:
• IEEE 802.11g Wireless Repeater
• Power adapter
• One CAT-5 Ethernet cable
• Installation CD containing the User Guide and installation
wizard
• Quick Installation Guide
Hardware Description
The Wireless Repeater can be connected to the Internet or to a
remote site using its WAN port. It can be connected directly to
your PC or to a local area network using any of the Fast Ethernet
LAN ports.
Although access speed to the Internet is determined by your
service type and the modem type connected to the Wireless
Router, data passing between the devices connected to your
local area network can run up to 100 Mbps over the Fast
Enternet ports.
The Wireless Repeater includes an LED display on the front panel
for system power and port indications that simplifies installation
and network troubleshooting. It also provides four RJ-45 LAN
ports and one RJ-45 WAN port on the rear panel.
• Four Ethernet ports for connection to a 10BASE-T/
100BASE-TX Ethernet Local Area Network (LAN). These
ports can auto-negotiate the operating speed to 10/100 Mbps,
the mode to half/full duplex, and the pin signals to MDI/MDI-X
(i.e., allowing these ports to be connected to any network
device with straight-through cable). These ports can be
connected directly to a PC or to a server equipped with an
Ethernet network interface card, or to a networking device
such as an Ethernet hub or switch.
• One RJ-45 port for connection to a DSL or cable modem
(WAN). This port also auto-negotiates operating speed to
10/100 Mbps, the mode to half/full duplex, and the pin signals
to MDI/MDI-X.
The following figure shows the components of the Wireless
Advertisement
Table of Contents
