Operation; Manual Control - ADJ ENTOUR CYCLONE User Instructions

Entour Cyclone
1. Open the shipping carton and carefully remove the unit from the shipping
carton.
2. Be sure to remove all the packing material especially around the nozzle.
3. The machine can be set on dry flat surface, hung from tussing (see page
11), or pole mounted.
4. Plug the unit into a matching power supply.
5. Follow the operating instructions on the next pages for proper operation.
Entour Cyclone
MENU BUTTON - Press this button to cycle between manual mode, DMX
channel mode, and DMX addressing. Use the UP and DOWN buttons to
adjust the DMX address and change the DMX channel mode.
UP BUTTON - Use this button to switch between DMX channel modes and
adjust the DMX address.
DOWN BUTTON - Use this button to switch between DMX channel modes
and adjust the DMX address.
SWITCH BUTTON - Use this button to turn the fan manually On/Off. The fan
speed is controlled using the Volume Air Adjustment Knob.
ADJ Products, LLC - www.adj.com - Entour Cyclone Instruction Manual Page 8
General Set-Up Entour Cyclone

Manual Control:

1. Connect the provided PowerCON cable to the Entour
Cyclone input. Then plug the power cord into a matching power
source. There is no ON/OFF switch.
2. Primary power is now "On". The display should read "VX ON
V1". This means you are in manual control mode. If this is not
displayed, press the MENU button until it is displayed.
3. Use the Volume Air Adjustment Knob to regulate the fan
output.
Control Panel
DMX Control:
1. Connect the provided PowerCON cable to the Entour
Cyclone input. Then plug the power cord into a matching power
source. There is no ON/OFF switch.
2. Primary power is now "On". Press the MENU button until
"DMX ADDR" is displayed. This is the DMX addressing menu.
Use the UP or DOWN buttons to adjust the DMX address.
3. Once you have found your desired DMX address, press the
MENU button until "DMX Mode" displayed. You can now set
your desired DMX channel mode. The Entour Cyclone has 2
DMX channel modes; 1 channel mode and 2 channel mode.
4. Connect the unit to DMX controller via 3-Pin XLR cables. See
page
ADJ Products, LLC - www.adj.com - Entour Cyclone Instruction Manual Page 9

Operation