Table of Contents
Advertisement
6.3 Data hold function
It will be possible to hold a measured value on the display, e. g. to be able
to read the value more easily when the test tips have been removed from
the object to be measured. For this purpose, press the button "HOLD
(4) briefly. "HOLD" will appear. To return to the present value, press the
button "HOLD " briefly to deactivate the function ("HOLD" will disappear).
6.4 Activating the display illumination
To activate / deactivate the display illumination, keep the button "HOLD
(4) pressed for approx. 2 seconds.
Note: With this button, the function "Data hold" (chapter 6.3) will be acti-
vated / deactivated at the same time. Press the button briefly to deactivate
or reactivate it.
7 Replacing the Battery or the Fuses
A If nothing is displayed or if the symbol
insert a new 9 V battery.
B If it is not possible to measure currents, check the internal fuses and
have them replaced by skilled personnel.
You will find the battery compartment and the fuse holders under the
housing cover on the rear side of the meter.
WARNING: Before opening the housing, remove the test tips
from the measuring points and the test leads from the jacks
on the meter, otherwise you will risk an electric shock. Never
operate the meter when it is open.
1) Fold up the tilt stand, release the two screws of the housing cover,
then remove the cover.
2) To replace the battery, remove the old battery, connect the battery con-
tacts to the new battery and insert it into the compartment.
Used batteries must not be placed in the household waste,
always take them to a special waste disposal, e. g. collection
container at your retailer.
Replace a defective fuse by one of the same type only:
range up to 400 mA
range up to 10 A
3) Screw down the cover again before setting the meter into operation.
F 0.5 AL/250 V
F 10 AL/250 V
(= low battery) is displayed,
GB
"
"
23
Advertisement
Chapters
Table of Contents
