Brookstone Panda Manual page 5

Noted:
1. If the pairing is not completed over 5 minutes, the earbuds will
automatically shutdown.
2. If the right and left earbuds are not completed with interconnection within
one minute, the earbuds will go into standby mode. If necessary, please
turn off the earbuds and repeat the above steps to connect.
Connection with last connected bluetooth device
In the state of power off, respectively press and hold the multifunction
buttons of right and left earbuds about 3 seconds, until the red and blue LED
lights flash alternatively, the right and left earbuds will inter-connect
automatically, with a beep tone of "connected" in both earbuds, subsequently
with the tone of "left channel" in the left earbud and "right channel" in the
right earbud, now the earbuds will automatically return connect with the last
connected bluetooth device (please make sure that the bluetooth function is
on), the left earbud will come out with the beep tone of "connected" with
successful connection. If it can't connect with a bluetooth device, please
connect manually.
3