Automatic Headlights - If Equipped - Dodge RAM CHASSIS CAB2018 User Manual

NOTE:
• The Automatic High Beam Headlamp Con-
trol can be turned on or off by selecting
"ON" under "Auto High Beam" within your
Uconnect settings, as well as turning the
headlight switch to the AUTO position. Re-
fer to "Uconnect Settings" in "Multimedia"
in the Owner's Manual
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca
(Canadian Residents) for further informa-
tion.
• Broken, muddy, or obstructed headlights
and taillights of vehicles in the field of view
will cause headlights to remain on longer
(closer to the vehicle). Also, dirt, film, and
other obstructions on the windshield or
camera lens will cause the system to func-
tion improperly.
If the windshield or Automatic High Beam
Headlamp Control mirror is replaced, the
mirror must be re-aimed to ensure proper
performance. See a local authorized dealer.
To Activate
1. The Automatic High Beams are enabled
through the Uconnect system. Refer to
"Uconnect Settings" in "Multimedia" in
the Owner's
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca
at
(Canadian Residents)
information.
2. Turn the headlight switch to the AUTO
headlight position.
3. Push the multifunction lever away from
you (toward front of vehicle) to engage the
high beam mode.
NOTE:
This system will not activate until the vehicle
is at or above 20 mph (32 km/h).
To Deactivate
1. Pull the multifunction lever toward you (or
rearward in vehicle) to manually deacti-
vate the system (normal operation of low
beams).
2. Push back on the multifunction lever to
reactivate the system.
Automatic Headlights —
If Equipped
This system automatically turns the head-
lights on or off according to ambient light
Manual at
levels. To turn the system on, rotate the
headlight switch counterclockwise to the
AUTO position. When the system is on, the
for further
headlight time delay feature is also on. This
means the headlights will stay on for up to
90 seconds after you place the ignition into
the OFF position. The headlight time delay
can be programmed 0/30/60/90 seconds.
Refer to "Uconnect Settings" in "Multime-
dia" in
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca
(Canadian Residents) for further information.
To turn the automatic system off, move the
headlight switch out of the AUTO position.
NOTE:
The engine must be running before the head-
lights will turn on in the Automatic Mode.
the Owner's Manual at
33