Flash-To-Pass; Windshield Wipers - Cadillac CTS 2008 Owner's Manual

Flash-to-Pass

This feature allows you to use the high-beam headlamps
to signal the driver in front of you that you want to pass.
Pull and hold the turn signal/multifunction lever toward
you to use this feature. When this is done the following
will occur:
•
If the headlamps are off, in low-beam or in Daytime
Running Lamps (DRL) mode, the high-beam
headlamps will turn on. They will stay on as long as
the lever is held there. Release the lever to turn
them off.
•
For vehicles with High Intensity Discharge (HID)
headlamps, the low-beam headlamps must be
on to activate the high-beam headlamps. See High
Intensity Discharge (HID) Lighting on page 5-55.
•
If the headlamps are already in high-beam mode,
they will remain on high-beam.

Windshield Wipers

The lever on the right side of the steering column
operates the windshield wipers.
7 (Mist): Pull the lever down and release it for a
single wiping cycle. The lever will return to its original
position. For more cycles, hold the lever down
before releasing it.
& (Delay): Move the lever to this position to set a
delay between wipes. Turn the delay adjustment band
to set the length of the delay.
6
(Delay Adjustment): Use this band to set the length
of the delay between wipes when using the delay
feature. The closer the band is moved towards
the longer the delay. The windshield wiper lever must be
in delay for this feature to work.
7
,
3-9