Commodore VIC-20 User Manual page 36

22
The VIC 20 User Guide
FIGURE
1·6.
Datassette connector
connector and into the slot. This makes it difficult to connect it incorrectly,
but it can be done, so be careful. In general, you may find a connector
difficult to remove once it is on, but it is rare to have trouble installing one if
it is positioned correctly. If the divider slides over the slot, you can be sure a
proper connection has been made.
To connect the Datassette to the VIC 20, follow these steps:
1. Turn the power
OFF.
2. Hold the plug so the divider will mate with the connector slot.
3. Gently push the plug onto the interface. Do not force the connection.
4. Make sure the connection fits securely.
5. Turn power
ON.
Testing the Datassette
Before you go any further, you should check the mechanical operation
of the Datassette. Here is a simple test you can use to make sure that all of
the control functions are operating properly.
1. Turn the VIC 20
ON.
Make sure that none of the cassette keys are
depressed and that the cassette drive motor is not running.