Features; Content In The Pack; How To Assemble Your Unit; Batteries - Tens AA User Manual

100µS in the next 6 seconds. Pulse rate is
selectable.
Mode E--- Modul II, Pulse rate and Pulse width
Modulation.
Frequency increase from 50Hz to 100Hz while
pulse width decrease from 200µS to 60µS
within 5 seconds.
Treatment timer:
Continuous,15min,30min,45min,60min, 90min
selectable.
FEATUERS
1. When mode changes, the intensity will
automatically go down to zero;
2. When the unit is turned on, it will
automatically enter the mode that the unit
had worked in before the unit was turned
off;
3. When the treatment timer is set, it will
begin to count down one minute by one
minute; Once it count down to Zero, the
unit will automatically shut off;
4. When the pulse rate, pulse width or
intensity is being adjusted, the auto-repeat
function is available, when the key is held
down over 1 seconds, it will automatically
increased/decreased 1 step per 1/4
seconds.

CONTENT IN THE PACK

Your TENS pack should contain the following:
• 1 x T.E.N.S. Unit
• 2 x Leads
• 4 x Self Adhesive Pads with Connectors
(size: 40mm X 40mm)
• 2 x Alkaline AA1.54V (LR6) Batteries
• 1 x Instruction Booklet (which you are
reading)
Having checked all the contents are correct
please proceed to assemble the unit.

HOW TO ASSEMBLE YOUR UNIT

Assembly of the TENS AA unit is very simple
and requires only five steps.
STEP 1 BATTERIES
Remove the battery cover and insert two
batteries, as shown on the diagram inside the
battery compartment. Replace the battery
cover.