Advertisement
Advertisement
Summary of Contents for Garrison 2498547
- Page 1 PACKAGED TERMINAL AIR CONDITIONER/HEAT PUMP Model: 2498546/2498547/2498548/2498549 2498550/2498551/2498552/2498553 2498554/2498555/2498556/2498557 2498558/2498559/2498560/2498561 Before using your air conditioner, please read this manual carefully and keep it for future reference.
-
Page 2: Table Of Contents
CONTENTS 1. SAFETY PRECAUTIONS..............2 2. IMPORTANT SAFETY INSTRUCTIONS ..........4 3. AIR CONDITIONER FEATURES............5 4. CONTROL PANEL OPERATION............6 5. DIP SWITCHES CONFIGURATION...........8 6. INSTALLATION..................11 7. CARE AND CLEANING..............13 8. TROUBLESHOOTING...............14 Read This Manual Inside you will find many helpful hints on how to properly use and maintain your air conditioner. -
Page 3: Safety Precautions
SAFETY PRECAUTIONS To prevent injury to users or others, and to prevent property damage, the following instructions must be followed. Incorrect operation due to ignoring of instructions may cause harm or damage. The seriousness is classified by the following indications. WARNING This symbol indicates the possibility of death or serious injury. - Page 4 ! CAUTION When the air filter is to be Do not clean the air Ventilate the room well when removed, do not touch the conditioner with water. used together with a stove, etc. metal parts of the unit. It may cause an injury. Water may enter the unit and An oxygen shortage may occur.
-
Page 5: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS For Your Safety WARNING NOTE The power supply cord with Do not store or use gasoline or other flammable vapors and liquids in this air conditioner contains a current the vicinity of this or any other appliance. detection device designed to reduce Avoid fire hazard or electric shock. -
Page 6: Air Conditioner Features
Operation of Cur rent Device(optional) The power supply cord contains a current device that senses damage to the power cord. To test your power supply cord: 1. Plug in the Air Conditioner. 2. The power supply cord will have TWO buttons on the plug head. Press the TEST button. -
Page 7: Control Panel Operation
CONTROL PANEL OPERATION The control panel keypad will look like the following Note: If the unit has DIP SWITCHES, the temperature range can be set and controlled by Fig.1. DIP SWITCHES. See DIP SWITCHES CONFI- GURATIONS on page 8 for details. UP/DOWN BUTTONS ( - Push the UP (or DOWN) button to increase (or Fig.1... - Page 8 CONTROL PANEL OPERATION (CONTINUED) Accessory THIS UNIT IS CONTROLLED BY Wall-Mounted THERMOSTAT NOTE: When the unit displays LC (pads on the control panel are not available. The unit can be set with a wire controller only.) You can install the accessory on the control panel.
-
Page 9: Dip Switches Configuration
DIP Switch CONFIGURATIONS (Optional) REMOVING THE FRONT PANEL - Dip switches are located behind the front panel, through an opening below the control panel. T access, remove front panel. See Fig. 2. - Dip switches are accessible without opening the control box. - Page 10 WALL THERMOSTAT TERMINAL (Optional) - Insert the wire connector of the wall t hermostat into IMPORTANT: Only trained, qualified personnel should access electrical panel on unit and install the relevant terminal according to different shapes (as shown below). electrical accessories. Please contact your local some types of wall Terminal of electrical contractor, dealer, or distributor for...
- Page 11 WALL THERMOSTAT TERMINAL (Optional) FRONT DESK CONTROL CAUTION The controller can handle a switch signal from FC(L) UNIT DAMAGE HAZARD and FC(N) input called front desk control. Input must be 24VAC.If system doesn't receive a 24VAC signal, Failure to follow this caution may result in it will turn unit off.
-
Page 12: Installation
INSTALLATION HOW TO INSTALL THE UNIT Dimension of air conditioner CAUTION 1067mm/42inch There are sharp edges that can cause serious cuts. When lifting the air conditioner , it is HEA . Use 2 408mm/16inch people to lift. - For existing sleeve, you should measure the wall sleeve dimensions. - Page 13 INSTALLATION (CONTINUED) UNIT INSTALLATION (CONTINUED) CAUTION - Rotate the vent control lever to open or close the vent door . (See Fig.6) Do not put obstacles, such as window curtains, around air inlet or inside of air inlet of the unit. Vent control lever Always insert the filter securely, and clean filter once every two weeks as required.
-
Page 14: Care And Cleaning
CARE AND CLEANING FRONT PANEL AND CASE - Removing Air Filter - Turn unit off and disconnect power supply o clean, 2 Air filters use water and a mild detergent. DO NOT use bleach and abrasives. Some commercial cleaners may Pull up damage the plastic parts. -
Page 15: Troubleshooting
TROUBLESHOOTING POSSIBLE CAUSES SOLUTONS UNIT DOES NOT START Check that plug is plugged securely in wall receptacle. Unit may have become unplugged Note:Plug has a test/reset button on it. Make sure that the plug Fuse may have blown has not tripped. Circuit breaker may have been tripped Replace the fuse. - Page 16 The design and specifications are subject to change without prior notice for product improvement. Consult with the sales agency or manufacturer for details.