Babyco L'Square Instruction Manual

PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE AS YOUR CHILD'S SAFETY DEPENDS ON IT.
-Suitable for babies that can sit up unaided approximately 6 months
-Suitable for babies with a maximum weight of 15kgs approximately 3 years.
-Complies with BS EN 14988 -1, 2006+A1 2012
-Adult assembly required
1. Parts.
Please keep all packaging until you are sure no parts are missing. Carefully dispose all packing
material, packaging and plastics that may result in suffocation if swallowed.
DO NOT USE IF ANY PARTS ARE MISSING OR BROKEN
1. Seat unit
2. 2.Two Part Serving Tray
3. Lower legs front & rear
4. Upper legs with height adjustment left & right
5. Foot rest & Securing screws
6. Stop washer & Screw
7. Seat cover (not shown)
Assembly
2. Fixing the Upper Leg
-Take the left or right upper leg, press the red (a) button as shown in diagram 2 and extend the leg and
release the button once the leg has been extended. Repeat the same with the other leg.
-Looking at the orientation in the diagram 2 put the front leg (the red button facing outside) through the
seat height adjustment bracket. Repeat the same with the other leg.
3. Fixing the Lower Leg
-Please note each of the four legs has a spring loaded pin. Line up the feet so the small hole to the pin.
Push firmly on both ends until the pin clicks into place of the hole of the lower leg as illustrated in
diagram 3.
4. Attaching the Footrest.
Attach the footrest under the seat unit till it clips on. Secure the footrest using screws provided. The
screws are to be fixed from the rear as shown on the diagram 4.
5. Fitting the Seat Cover.
Slide the pocket at the back of the seat cover over the seat unit as shown in diagram 5. Ensure the studs
are fastened on each side. ALWAYS CHECK THE STUDS AND HARNESS IS FIXED CORRECTLY. DO NOT
USE IF SEAT OR ANY PART OF THE SEAT IS TORN OR DAMAGED
6. Fitting of Tray
Position the tray over the arms and press the leaver under the tray to slide the tray into position
required. The upper tray can be removed by holding the two ridges on either side and pulling it and can
be put back by pushing it into space ensuring it is secure. The tray can be stored behind the pegs that
are on the rear legs of the high chair. Align the holes on the back of the tray with the pegs.
L' Square High Chair
INSTRUCTION MANUAL