Advertisement
MANUAL ENGLISH
2.
2. Push the teach-in button on the receiver until the red LED
lights up.
3. Release the button when the red LED light up.
4. Turn transmitter ON.
5. Push on any button of the transmitter that is to be used with
the receiver. The ID-code will be programmed into the
receiver, and the red LED will blink three times.
6. Check if the functions are correctly working by pushing the
buttons of the transmitter and checking if the relays are being
activated. The green LED will light up if the receiver receives
the signal from the transmitter. When the transmitter is
programmed into the receiver, the red LED in the receiver
will blink continuously two times.
STOP INSTRUCTION
The teaching-in procedure can be stopped by pushing the button
in the receiver for 6 seconds.
ERASING THE PROGRAMMED TRANSMITTER
You can erase the programmed ID-code of the transmitter by
pushing the button on the receiver for more than 8 seconds.
TROUBLE SHOOTING:
If the equipment does not work like it should, please check the
points here under.
Rev 1 date 26-04-11 RS
6-8
Advertisement
