Table of Contents
Advertisement
Flexi TENS Instructions.qx6
Setting up your Flexi TENS
Check you have the following contents:
1 x Flexi TENS
1 x Pack of 4 self adhesive electrodes
1 x Single leadwire
1 x Dual leadwire
2 x AAA batteries
1 x Carrying pouch
1 x Neck cord
The assembly stage
1. Slide open the battery cover on the back of the
unit to expose the battery compartment.
2. Insert the batteries according to the diagram
found in the battery compartment. Replace the
cover.
3. Select the leadwire that you wish to use for your
treatment:
a). The single leadwire can be used to treat
one pain area as indicated on pages
8 and 9 OR
b). The dual leadwire can be used to treat
two pain areas, or a large pain area such as
your back. See the diagrams on pages 8
and 9.
4. Insert the plug end of the leadwire into the jack
plug socket at the bottom of the Flexi TENS.
5. Connect the electrodes to the pin ends of the
leadwire (see diagram below).
Insert a red
and black pin
(at the end of
the lead wire)
into each pair
of electrodes.
15/8/06
6
14:13
Page
Advertisement
Table of Contents
