EnGenius EWS2910P User Manual page 41

EWS Wireless Management Switch User Guide
Scaling Tool: Use the scaling tool to determine the exact distance on the floorplan.
Signal Indicator: The colored indicator displays the reference signal strength covered.
RF Coverage
Enable: Select to display wireless coverage on your floor plan.
RSSI Value: Adjust RSSI value to emulate using the slider bar.
Calibration Offset: Use the slider bar to adjust the offset value based on the deployment.
RSSI Range Simulate: Check the RSSI Simulate box to display RSSI reference on your floor plan. Adjust
RSSI coverage range to emulate using the slider bar.
Navigating Tips
Use to scroll up, down, left, or right.
Use to Zoom in/out. Alternatively, you can use the mouse to navigate by clicking and dragging the left
mouse button. Use the mouse wheel to zoom in/out.
Mouse over a device to show information about the device.
AP List: Click to reveal a list of APs that the EWS Switch is currently managing.
The number in the marker represents the number of wireless clients that are currently connected to the
Access Point.
Left click on the Access Point marker to bring up a menu where you can configure AP settings, remove AP
from management list, reboot AP, redirect to the Active Clients page or redirect to troubleshooting page.
Click on for the settings to take effect.
41 / 60