Related Manuals for SMART/RG PL60
Summary of Contents for SMART/RG PL60
-
Page 1: Quick Start Guide
Quick Start Guide PL60 /PL62AC This Quick Start Guide shows you how to set up and begin using your new powerline adapters. - Page 2 être installé à proximité du matériel et doit être aisément accessible. Minimum requirements for using the PL60 and PL62AC are: Ethernet Network interface (10, 100 or 1000 Mbps transfer rate) Router with Internet connection and one available LAN port...
-
Page 3: Led Indicators
LED INDICATORS The LEDs on the front of the PL60 can help you understand the current state of your adapters. Action Meaning Power Adapter is on. Adapter is setting up security Adapter is in power-save mode Ethernet Ethernet port is connected... -
Page 4: Connection And Controls
Plug a power strip into the front of the PL60 for additional filtered capacity. The bottom of the PL60 has 2 buttons and a gigabit Ethernet port. The PL62AC has 3 buttons and a gigabit Ethernet port. -
Page 5: Installation
INSTALLATION Using one of the supplied Ethernet cables, connect the PL60 adapter to your router. Plug the unit into an AC outlet. The Power and Ethernet LEDs should both light up. ETHERNET Plug in the PL62AC adapter in the room where you wish to extend your network. The Power LED will light up. - Page 6 Confirm that the Data LEDs on both adapters are lit, indicating the adapters are con- nected. If not, try a different wall outlet located closer to the PL60 adapter. Using the remaining, supplied Ethernet cable, connect your device to the PL62AC adapter.
- Page 7 SECURITY Adapters on the same network must use the same encryption key. Any PL60s (or PL62AC) using the default encryption key will communicate successfully. To help protect your network from unauthorized access via the power lines, it is recom- mended that you create a private encryption key to replace the default key. To create a private encryption key, follow these steps: 1.
-
Page 8: Expand Your Pl60 Network
EXPAND YOUR PL60 NETWORK If you would like to add more than 2 adapters, press the Link button of the additional adapter for no more than 3 seconds. The Power LED blinks after you release the button. Within 2 minutes, press the Link button of any adapter in your existing network for no more than 3 seconds. -
Page 9: Fcc Statement
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, p ursuant to part 15 of FCC Rules. These limits are designed to provide reasonable protection again st harmful interference in a residential installation. This equipment generates and can radiate radi o frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Need help?
Do you have a question about the PL60 and is the answer not in the manual?
Questions and answers