Installation
Installation of the transmitter batteries:
Use only 8cell/9.6V rechargeabl e battery pack in the Commander series
transmitter. An 8cells NiMH rechargeable battery pack and wall charger are
enclosed in the box. Please refer the following pictures to install the
rechargeable battery pack into the transmitter.
Battery cover
While pressing
this part
HELPFUL HINT
You may also use the NiCd or NiMH
rechargeable cells. They can be charged
through the charge jack located on the
side of the transmitter. The ACE 2946
Hi-MH battery pack / flat & 2970/2971/
2972 Radio battery conversion kits are
recommended.
Cord to transmitter
external charging jack
CAUTION
When the transmitter will not be used for any short or long period,
always remove the batteries.
Receiver battery replacement/installation
Insert 4 fresh AA cells into the
receiver battery holder. Make
sure the batteries are loaded in
the correct polarity order. Main-
tain the battery contacts in the
same way as described in pre-
vious section.
Insert the switch harness plug
into the receiver socket marked
"BATT"
Ni-MH Battery Pack
3
3