Transmitter Controls - ACE RC Sky Commander T4A 8418 Instruction Manual

Transmitter Controls

1. Right Stick: CH1 & CH2 control for Mode1 type. CH3&CH4 control for
Mode 2 type.
2. Left Stick: CH3 & CH4 control for Mode1 type. CH1&CH2 control for
Mode 2 type.
3~6. Channel Trim TAB: Using these functions to trim the control to neutral
position of the relative servos of each channel.
7. Power Switch: Turn the transmitter on or off.
8. Antenna: Never operate the transmitter without extending this antenna
or you may create interference to other modeler.
9. Voltage Indicator: These 3 LED lights will indicate the condition of the
transmitter battery. There are "Green"(left), "Yellow"(middle) and "RED"
(right) to show the battery condition is "Good", "Fair" and "Poor". When
the middle "Yellow" LED light on, it means that the transmitter still work
and remind you have to charge the battery pack. When the right "RED"
LED light on, then you have to call back you model and stop the operating.
Otherwise, you may loose control of your model due to loose the
transmitter signal.
10. Trainer Switch(Only available for T4A & T6H): Trainer switch is function
to change the model control right between the student and coach. A
coach cable must be connected with the coach and student transmitter.
And this switch is control by the coach*s transmitter.
11. Servo Reversing & Mixing Function :
a) T4A The left 4 switches function to reverse the
direction of the Ch1~Ch4 servos. When adopt the V-
tail or Elevon mixing function, set the 6th switch on
the *ON position. The set the 5th mixing function you
want to use.
b) T6H/T6M * The 6 switch function to reverse the
direction of the Ch1~Ch6 servos.
12. Crystal: The frequency could be changed by replacing the new crystal
set. It is recommend to use the original manufactured crystal set and
to change the transmitter and receiver crystal at same time.
13. Charging Jack: Recharge the transmitter battery only as using a
rechargeable NiHM battery pack.
NOTE
Set the Power Switch switch on OFF* position before charging. And
the charger plug must be correct type (+* inside and -*outside, type
TAMIYA N-3U or equivalent). The wrong type may burst causing personal
injury and damage.
14. Simulator/Trainer Port: This port is designed to connect to the PC
simulator or another transmitter to do the training with a suitable cable
device. This trainer port is 9C connector type. So the cable you use,
must have the same 9C connector type on the end. TT#2707 FSU Flying
Simulator USB connector is recommended to connect to the FMS
simulator. And the #AT0148 Trainer Cable is recommend to use for the
flying training.
15. 5th Channel Control Switch: Function only available for T6H & T6M.
On T6H, this function is for the adjusting of Gyro Gain.
16. 6th Cannel Control Switch: Function only available for T6H & T6M.
On T6H, this function is for adjusting Flight Mode*.
15
3
2
4
9
12
11
2
2
8
16
5
10
1
6
14
13
7