Table of Contents
Advertisement
[Final Draft—Nortel Confidential]
Chapter 2
System Configuration
The Access Point 2220 can be configured by any Java-supported Web browser
including Internet Explorer 4.0 or above, or NetScape Navigator 4.0 or above.
Using the Web management interface, you may configure the Access Point 2220.
You can also use the command line interface (CLI) to manage the Access Point
2220. (Refer to "Run Time Console Specifications" for complete information on
the CLI.)
To initially manage the Access Point 2220, you must configure the network
settings of the computers on your wireless LAN to use the same IP subnet as the
Access Point 2220. The default network settings assuming there is no external
DHCP server for this device are:
Access Point IP Address: 192.168.168.10
Gateway IP Address: 192.168.168.254
Subnet Mask: 255.255.255.0
The IP address of the connected client PC from which system configuration is to
be performed should be 192.168.168.x (where x means 1–9, 11–253).
If DHCP is enabled, (default setting is "Enable," page 41) and a DHCP server is
located on the network, then the access point will automatically be assigned an IP
address when booted.
To access the Access Point 2220's management interface, enter the IP address of
the device in your Web browser:
http://192.168.168.10
The Web management window will appear.
Chapter 2 System Configuration
Using the Nortel Networks Wireless LAN Access Point 2220
19
Advertisement
Table of Contents
