Page 2
All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit www.horizon- hobby.com and click on the support tab for this product. The following terms are used throughout the product literature to indicate various levels of...
Page 3
Main Rotor Transmitter On/Off Switch / SD Card Charging Card Reader Port USB Charging Cable Props Photo/ Video Charging Port ON / OFF MIN. (OFF) (Solid Red) Connect the charging cable to the quadcopter, paying close attention to the on the port. Connect the charging cable to a powered USB.
Page 4
To start your quadcopter, follow this starting sequence: Power on the transmitter. The transmitter beeps. With the quadcopter on a level surface, power on the quadcopter. The quadcopter LEDs flash. Fully raise the stick. The transmitter emits one short beep. Fully lower the stick.
Page 5
The quadcopter has 3 operation modes: beginner, intermediate, and advanced: Press the stick in to enter the setting mode. The transmitter beeps once, indicating beginner mode (sensitivity 30%). The transmitter beeps twice, indicating intermediate mode (sensitivity 50%). The transmitter beeps three times, indicating advanced mode (sensitivity 70%).
Page 6
The quadcopter has 4 flip directions. Press the stick. The transmitter beeps, indicating flip mode. The quadcopter can perform 360 degree arial flips. The quadcopter must be at least 1m above the ground. After setup, press the key on the transmitter. The red indicator LED on the quadcopter flashes once per photo taken.
Page 7
(iii) modification of or to any part of the Product, (iv) attempted submission process found on our website or call Horizon to service by anyone other than a Horizon Hobby authorized service obtain a Return Merchandise Authorization (RMA) number. center, (v) Product not purchased from an authorized Horizon Pack the Product securely using a shipping carton.
Need help?
Do you have a question about the rezo RTF and is the answer not in the manual?
Questions and answers