Table of Contents
Advertisement
• Setting Flash Mode
1. Turn on the camera by sliding and holding the Power Switch in the
arrow direction shown near the switch for 2 seconds.
2. Set the Camera in Auto or A/S/M mode.
3. Press the Flash button to cycle through the flash settings and select
the one you need.
When you press the Flash button, the Flash Charge LED will blink in red,
which indicates the flash is charging. The icon (according to the flash
setting you selected) will appear on the LCD screen. You can now take
pictures using the Flash mode you selected. The flash will recharge after
each flash picture.
Flash Range:
• Wide: 2.6 ~ 9 feet (0.8 ~ 2.7 metres)
• Telephoto: 2.6 ~ 6.7 feet (0.8 ~ 2.0 metres)
The camera has six flash modes (default setting is Auto). Use the flash
when you take pictures at night, indoors, or outdoors in heavy shadows.
A
Auto Flash Mode. The flash fires automatically as needed. Use this
setting to take most pictures.
Flash Mode on. The flash fires for every picture. Use this setting in
high-contrast situations to provide fill-light or use it indoors in low
light.
Flash Mode off. The flash does not fire. Use this setting for outdoor
pictures or where flash is prohibited or may be distracting. Also use
when shooting toward a reflective surface, such as a window or
mirror. If you do not have enough light when using this setting, your
pictures will be too dark.
Red-eye reduction. The flash fires automatically as required by the
lighting level, and the flash pre-strobes before shooting to reduce
red-eye phenomenon.
Polaroid PDC 5350 Digital Camera User Guide
www.polaroid-digital.com
25
Advertisement
Table of Contents
