Page 1
Owner’s Manual: 19600 Title: KC-1200 Dual Surface Extractor Serial number:__________________ The ServiceMaster Company Revision: E 860 Ridge Lake Blvd. ServiceMaster® Manual Memphis, TN 38120 Copyright 2004 by 800-756-5656 (Tech Support) ServiceMaster Clean Date: 07/31/09 All rights reserved...
Page 2
CAUTI ON: DO NOT OPERATE MACHI NE UNTI L YOU HAVE READ ALL SECTI ONS OF THI S I NSTRUCTI ON MANUAL I MPROPER USE OF THE MACHI NE WI LL VOI D THE WARRANTY . Always use a defoamer when foaming occurs to prevent vacuum motor damage. .
I MPORTANT SAFETY I NSTRUCTI ONS This machine is only suitable for commercial use, for example in hotels, schools, hospitals, factories, shops and offices other than normal residential housekeeping purposes. When using any electrical appliance, basic precautions should always be followed, including the following: NOTE : Read all instructions before using this machine.
I NSPECTI ON: Carefully unpack and inspect your KI NG COBRA-1200 for shipping damage. Each machine is tested and inspected before shipping. Any shipping damage incurred is the responsibility of the carrier. You should notify the carrier immediately if you notice damage to the box or to the machine or parts. CLEANI NG SOLUTI ONS: Select a proper pre-spray for the surface to be cleaned, and apply the pre-spray.
KNOW YOUR MACHI NE Vacuum Hose Wand Holder Connection Switches Hoses Recovery Tank 1200 PSI Quick Latch Disconnect Auto-fill Solution Hose Tank Connector Wheel Base Compartment 150 psi Quick Disconnect Wand Holder Vacuum Hose Connection Recovery Tank Recovery Tank Dump Hose Power Cord Recepticle...
Page 6
SWI TCH PLATE HIGH DUMP PUMP PRESSURE ON/OFF PUMP SWITCH I NDI CATOR CIRCUIT LOCATOR HEAT 150 PSI LIGHT INDICATES I NDI CATOR PUMP TWO CI RCUI TS. PUMP/HEAT ON/OFF VACUUM SELECTOR SWITCH ON/OFF SWITCH SWITCH This light will turn on to indicate the your two power cords are plugged into two circuits. I f this light does not turn on, keep trying outlets with one of the cords until you get the green light to turn on.
Page 7
LOW PRESSURE continued NOTE fill : I f you are not going to use the auto-fill system, just the tank with water and cleaning chemical. Follow chemical directions regarding dilution and mixing. Do not use harsh chemicals; they may damage seals in pumps and valves, and cause the pump to wear prematurely. NOTE °...
Page 8
HI GH PRESSURE continued damage seals in pumps and valves, and cause the pump to wear prematurely. NOTE : Never use water with a temerature exceeding 130 ° F / 54 ° Pre-spray the area to be cleaned, with a pump-up sprayer, while the tank is filling. Follow chemical directions.
Page 9
AUTO-FI LL Operat ion: • Attach a 3/ 4” garden hose to the autofill valve, a nd connect the other end of the hose to your water source. • Make sure the float that hangs from the autofill v alve into the tank is free of obstruction and can move freely. •...
Page 11
1 9 6 0 0 K I N G COBRA-1 2 0 0 PART LI ST 1 2 0 V I TEM PART No. DESCRI PTI ON ITEM PART No. DESCRI PTI ON 1303 Switch Plate FP420 Hose, Pump to Gauge, complete Light, green, 120V FP371 Heat Exchanger, complete...
Page 12
NOTES: The ServiceMaster Company 860 Ridge Lake Blvd. Memphis, TN 38120 800-756-5656 (Tech Support) Date: 1/26/09...
Need help?
Do you have a question about the KC-1200 and is the answer not in the manual?
Questions and answers