PAL System I to I Dungle NTSC System PH to F Dungle RCA to Phone Jack Cable Remote Control Hardware Installation 1. The step by step installation of TV tuner module on 17” TFT LCD monitor is described below. PRESTIGIO TP03 TV Tuner Module...
Page 2
4. Slide the TV tuner module into the right side of the spare space of the back of monitor, and gently plug the optional TV tuner into the connector mentioned at Step 3 . 5. Screw to fix TV tuner module on the supporting sheet metal and re-install the color back panel. PRESTIGIO TP03 TV Tuner Module...
Page 3
EXIT to confirm. You will see 5 a blank screen and the tuner will be set to proper local system as selected. (OSD menu will disappear after EXIT pressed.) PRESTIGIO TP03 TV Tuner Module...
Page 4
When selected channel signals displaying is unstable, repeat Step1and press MENU button under TV/CATV mode, then press ADJUST buttons to choose CH FINE TUNE option. Press MENU again to enter CH FINE TUNE selection as shown in Figure 5. Press ADJUST buttons to adjust the displaying signals of selected channel. PRESTIGIO TP03 TV Tuner Module...
Page 5
JAPAN Japan WEST EUROPE Austria, Spain, Holland, Thailand, Iceland, Norway, Sweden, Finland, Denmark, Switzerland, Portugal Australia, New Zealand ITALY Italy GERMANY Germany CHINA China U.K-H.K United Kingdom, Hong-Kong FRANCE France SINGAPORE Singapore, Malaysia KOREA Korea PRESTIGIO TP03 TV Tuner Module...
2. Do not place the remote under direct sunlight or area with high humidity. If the remote control fails to operation, replace the battery in the remote control. Notice: Insert battery (Lithium battery) with its terminals corresponding to the <+>and <-> indications in the battery compartment. PRESTIGIO TP03 TV Tuner Module...
1. Check if the channel you’re watching is the only channel without screen. 2. Make sure if other channels also have no screen… 3. If the above actions still cannot resolve the problem, please contact your dealer or store where you purchased the product. PRESTIGIO TP03 TV Tuner Module...
Page 8
Important Note: Press the “Source” button on the Remote Control will cause not display in TV/CVBS/S-Video mode, users must Press the “+” keypad on the front of Panel to select TV/CVBS/Video mode again for display again. PRESTIGIO TP03 TV Tuner Module...