Panasonic VL-SW274 Quick Manual page 10

3. Preparation
B
Close the battery cover.
R The battery level is displayed as
A
2
Assemble the charger stand.
To assemble the charger stand
A
Plug the connector of the AC adaptor into the
jack on the charger.
R You can pull out the AC adaptor cord to the
left or right side.
B
Attach the charger stand.
A
B
To remove the charger stand
Pressing the tab, pull the charger stand to detach.
3
Plug the AC adaptor into the power outlet, place the
sub monitor on the charger, and charge the battery.
While charging: The CHARGE indicator (A) lights
up.
When charging is complete: The CHARGE indicator
(A) turns off.
10
.
B
A
R At the first time of charging or after battery
replacement, it takes about 7 hours to complete
charging.
R If you use the sub monitor while charging, the
charging time becomes longer.
R Locate the charger where "OUT OF RANGE" is not
displayed on the sub monitor.
(The charging time becomes longer where the sub
monitor is out of range of the main monitor.)
R Even after the sub monitor is fully charged, the sub
monitor can be left on the charger without any ill
effect on the batteries.
Important:
R Use only the included AC adaptor.
R When the sub monitor is off the charger or the
AC adaptor is disconnected for 1 week or more,
remove the battery in order to maintain the
battery performance and prevent the battery
from discharging.
– Recharge the battery before using the sub
monitor again.
3.4 Setting the language, date
and time
R The play lamp lights if these settings are not
configured.
1
Press the M N button to turn on the display.
2
Press or
language.
3
Press .
4
Press again.
5
Set the date and time.
R Press to select an item (i.e., year,
month, day, etc.).
R Press or
6
When finished, press
Note:
R The date and time settings may be deleted when
there is a power outage. In this case, reconfigure
the settings.
R The time may become out of sync over time (about
60 seconds per month).
to select the desired
to change the setting.
.