Toe Alignment - Polaris Scrambler 9921777 Owner's Manual

Polaris industries all-terrain vehicles owner's manual
Table of Contents

Advertisement

MAINTENANCE

Toe Alignment

Use the following procedure to check the toe alignment of the vehicle.
The recommended toe alignment is 1/8" to 1/4" (3-6 mm) toe out.
WARNING! Severe injury or death can result from improper toe alignment and
adjustment. Do not attempt to adjust tie rod alignment. All tie rod adjustments
should be performed by an authorized Polaris dealer.
1. Position the vehicle on a level surface.
2. Set the handlebars in a straight-ahead position and secure them in
this position.
3. Place a chalk mark on the
center line of the front tires
approximately 10" (25.4
cm) from the floor, or as
close to the hub/axle center
line as possible. Make sure
both marks are the same
distance from the floor.
4. Measure the distance
between the marks and
record the measurement (1).
5. Move the vehicle until the
chalk marks are at the rear
of the tires, even with the
hub/axle center line.
6. Measure the distance between the marks and record the
measurement (2).
7. Subtract measurement 2 from measurement 1. The difference is the
vehicle toe-out alignment.
8. If you discover improper alignment, see your Polaris dealer for ser-
vice.
74
2
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

2009 scrambler 500 4x4

Table of Contents