Table of Contents
Advertisement
MAINTENANCE
Steering Assembly
The steering assembly of the vehicle should be checked periodically for
loose nuts and bolts. If loose nuts and bolts are found, see your Polaris
dealer for service before operating the vehicle.
Camber and Caster
The camber and caster are non-adjustable.
Rear Spring
The rear shock absorber spring is
adjusted by rotating the adjuster (1)
either clockwise or counterclockwise
to increase or decrease spring
tension.
NOTE:
Accessory springs are
available through your
Polaris dealer.
Throttle Cable Freeplay
1. Locate the throttle cable adjuster
at the handlebar.
2. Squeeze the end of the rubber
boot (A) and slide it far enough to
expose the end of the inline
cable adjuster (B).
3. Loosen the adjuster locknut (C).
4. Rotate the boot to turn the
adjuster until 1/16" to 1/8"
(1.5-3 mm) of freeplay is
achieved at the thumb lever.
NOTE:
Move the throttle lever back
and forth while adjusting.
5. Tighten the locknut.
6. Reinstall the boot(s) to their original
position.
NOTE:
Engine RPM should not
increase when steering is
turned full left or right.
Readjust cable freeplay if
this occurs.
76
1
A
C
B
1/16
(1.5-3 mm)
A
to 1/8
"
"
Advertisement
Table of Contents
