Battery Removal; Battery Installation - Polaris ATP 330 4x4 Owner's Manual

MAINTENANCE AND LUBRICATION
Battery
Improperly connecting or disconnecting battery cables can result
in an explosion and cause serious injury or death. When removing
the battery, always disconnect the negative (black) cable first.
When reinstalling the battery, always connect the negative (black)
cable last.

Battery Removal

1. Disconnect the battery hold-down strap and remove the battery cover.
2. Disconnect the black (negative) battery cable first.
3. Disconnect the red (positive) battery cable next.
4. Lift the battery out of the ATV.

Battery Installation

When installing a new battery, make sure it's fully charged prior to its
initial use. Using a new battery that has not been fully charged can
damage the battery and result in a shorter life. It can also hinder
vehicle performance. Follow the battery charging instructions on page
114 before installing the battery.
1. Ensure that the battery is fully charged.
2. Set the battery in the battery holder.
3. Connect and tighten the red (positive) cable first.
4. Connect and tighten the black (negative) cable last.
5. Reinstall the battery cover and attach the hold-down strap.
6. Verify that cables are properly routed.
WARNING
113